no picture no tone since 6.63.9

#1
Hi,

I am using ProgDVB since a while without problem with multiple version.
Everything was fine up to 6.63.8. With update to 6.63.9 I had no picture no sound. Same for 6.63.10. Reinstalling 6.63.8 made it work again.

All installs over previous version, no deletes. Including downgrade.

What feature was added to break my system? Any additional setting to make?

My setup:
AMD Athlon PC,
Win XP SP3
Nvidia 7600GT graphics, (drv 6.14.11.7470)
Hauppauge WinTV DVB-T card, (drv 2.122.26109.0)
ffmpeg decoder

Re: no picture no tone since 6.63.9

#5
Hi Prog.

1. Signal is OK, after downgrade to version 6.63.08 everything works fine
2. I did not find "use only one tuner" option. But there is option "not start more one device at once". I selected it, but it does not help and I could not run device options again. With this setting does not work neither version 6.63.08. I had to manually edit ProgDVB.ini and set SetIsNotStartMoreOneDeviceAtOnce=0 to make version 6.63.08 run again

Re: no picture no tone since 6.63.9

#13
Perhaps you should both make a good photo of your tuners and upload each somewhere, to make it available here.

AFAIK, hauppauge used several different hardware concepts for their Nova-T models, based on different chipsets.
Of course, tuner handling depends on that hardware, specially if it's about BDA options.
Occasionally I have had a few different Nova-T / Nova-t models here, some base on Philips SAA7146 + TDA10045, others on Connexant chips.
So, same as with the Nova-S, there are original TechnoTrend designs, but nowadays most seem to be alike Twinhan or whatsoever.
Why should our lifes be easy...
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>

Re: no picture no tone since 6.63.9

#15
Installed 7.0.29209 (CD2.4) works OK. Uninstalled previous program & drivers prior to install because of error message didn't change any default settings.

Error: Win TV7.exe entry point not found. Yet to be investigated - if I click [OK] program starts OK.

(Similar message when starting ProgDvbNet)
Rgds