Display posts from previous
Sort by

#2 by Juergen
You must set the correct transponder frequencies and data rates, that are used by your cable provider, on your location.
Are you really sure to have access to digital cable?
If not booked, it's possible, it's filtered out and only analogue or even just a part of it available on your flat...

However, either you can find a transponder list, that's valid for your place, or edit your own one, or you have to scan each frequency manually.

BTW, does your device use BDA drivers?
If so, you should first install the original software, that came with it, and set it up and test it completely.
Even in case of WDM drivers, that procedure also won't harm you, and perhaps give you an idea on what's wrong...
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!


I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!

1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>