What I see is Dscaler and SD MPEG-encoders for tunner aren´t necessary for DVB-T, I installed them and later uninstall, and all works with Nvidia or Powerdvd codecs...
OK, I use Dscaler only for audio AC3.
josepz wrote:For analog not sure, because I can´t make it work, with or without Dscaler and SD MPEG-encoders...
Analog should work with only SD MPEG-Encoders (not with Dscaler wich is only for DVB-T because is a decoder filter) but don't work with my Pinnacle 310i.
When i activate the device in the window of proprieties of PROGDVB analog module in "standard video" in the options are PAL_B,PAL_D,PAL_60?,ECAM_H? but not PAL G.
If I select "Pinnacle PCTV Analog tuner...." in the bottom proprieties there are all correct standard video but the signal is not detect.
VCR flag do nothing.
Closing the windows i have a message box "Error to connect mpg-2 filters".
If i select "custom" in the proprieties of analog module i have to select "Cyberlink muxer" or "PCM MPEG muxer". The last, wich software have installed them?
Audio and Video codec ....nothing to select (blank list).
josepz wrote:Maybe what I will say is an stupid thing, but, Have you tried with the blind scan for the Italian analog channels?
Yes, the two time it works i' ve tried blind search because i know the channel/frequencies in my region.
josepz wrote:I have too Pinnacle BDA tuner in device list, first is for S-VHS and component -in, that corresponds with my Pinnacle Svideo-in rear connector, and composite rear connection, and the second that is for video tunner, the right choose for sintonize analog channels.
josepz wrote:At times I get a message saying "Selected video codec and multiplexer can´t accept signal from tunner"
I have never see this message...
josepz wrote:Maybe that is the problem for me, so I will continue fighting with this fool card...
If finally I can get analog channels working, I will post how I do, I think Italian and Spanish channel are very close, and maybe can help you too.
. In Italy within two years the analogic stream are in switch-off. I think of our card work perfecty in three years.
Akad wrote:Are you sure, that Russia and Italy frequency are the same?
P.S. Why you editing Russia.ini? Copy it to Italy.ini and edit it. When you install ProgDVB again, you changes in Russia.ini void.
I do it
UHF frequency are the same but VHF not. I have edited by this italian site (look please)
In the file, what is inversion?
And this is the syntax of file:
2=Italy TV Channels
;Position = Channelname,Frequency(KHz),Inversion(0,1),0,Bandwidth (7MHz=1, 8MHz=2)
But the description line isn' t wrong??? It should be:
;Position = Channelname,Frequency(KHz),video standard (PAL_[x] , SECAM_[x] )
I hate Pinnacle!
In italian forums all user with these card-usb stick are angry with a pinnacle software slow, greddy and buggy.
Another problem is remote control. WinLirc don't work because the sensor is connected directly in the card and not in COM port.
This card seem to work with linux and i've found the file .cfg for LIRC (in WINLIRC 0.65 don't work). If you search T.P.M. (french software) you found a nice program but i have a problem with a file "profiles.ini" (?????) during installation...