i bought Geniatech DigiStar 3 - DVB-S PCI where it come with ProgDVB 4.75 after install it, it give about 60% change from 50% till 65% Level while the quality constant at 1%, knowing that the same cable come from LNB with 2 outputs cable with no DiSEqC & i test the cable & work normally in my reciever but on the card give the Level 1%.
What is the problem & is there a solution?
Thanks...

I am recommend use last ProgDVB and BDA driver.

thanks for your reply
i use as u suggest, but the same Quality 0% while Level 100%
so, what problem could be from?
Thanks again

Hy,

I have also this Problem, and i think in this thread ist even this Problem:
viewtopic.php?t=4917
but i now a work around for that.

First I want to say, i have a LogiLink USB DVB-T stick with an EC168 Chip. Those Stick are available from many other firms with other labels.

If I start, before I start the ProgDVB, the original Software, or e.G. the Software BlazeDTV, and then I closed that Programs. Now I start ProgDVB, then I can use that Programm.

I think there is an initialising Problem with the EC168 Chip.

I hope there will be soon a fix for that Problem.

By
Torsten