Did it work before?
Does this also happen with another software?
If so, you are supposed to have a hardware problem.
But there are different possible reasons then:
First of all, the LNB supply stage of the Twinhan may be broken. Is it still under warranty? Else perhaps a TV mechanic or any other electronics expert may be able to help you.
In any case, have the LNB supply voltage checked, must be around either 13 or 18 Volts DC, without and with LNB attached..
Also possible, your LNB (now) needs more supply current than your card can deliver. This may f.e. happen if the outdoor connector is corroded.
Or did you change anything on that cable recently?
BTW, which way ever, never detach or attach LNB cables with mains plug (of computer or receiver) inserted, as then static discharge or (temporal) short circuit may ruin your tuner.
Please read here:
On Bug Reports And Other Complaints
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
DVB-Cube <<< Das deutsche DVB-Forum >>>