TBS 6921 and TBS 8921 probably Diseq problem.

#1
Hi all!

I am having the problem that ProgDVB only plays any channels on diseq position 1 on position 2,3 and 4 it finds channels and get signal but quality = 0 and no picture or sound.

Some details Windows 7 X64 Ultimate, latest drivers and TBS.eBDA from http://www.tbsdtv.com/, SPAUN SAR 411 F Diseqswitch and ProgDVB version 6.63.6 , 6.63.7 and 6.63.8 x32.

I have checked and tried different settings under Settings / Deviceoptions.........

With the TBS.eBDA that comes with the program does the cards not even start.

The setup works with other DVB program........

Any ideas ?

Re: TBS 6921 and TBS 8921 probably Diseq problem.

#3
Hi !

I did an completely new clean install of the latest ProgDVB version 6.63.8 no added modules and no extra and the result is that the card does not start ............as seen in the submitted screencap and the Settings->Device options is not reachable.

but if I replace the original TBS.eBDA with the one from http://www.tbsdtv.com/ then i can add my Diseq switch and satellites BUT I only get any picture on channels on satellite pos 1 .....on satellite position 2,3 and 4 all channels is found and get signal but quality = 0 and no picture or sound.

The setup works with other DVB program........

Best Regards.
/Anders
Attachments
ProgDVB 1.jpg
cron