BDA settings possible improvement
Posted: Fri Feb 03, 2012 10:33 pm
As i signaled in earlier posts, i have a problem on satellite scan on my Skystar HD (with BDA drivers), when the scan progress just hangs, the scanning ending with "Device not found".
I traced the problem back to the fact that the symbol rate is to small for some transponders for the given hardware.
Removing these transponders solves the problem (somewhere around 3500kS/s).
Now my proposal: In the BDA properties dialog in TV sources, is it possible to have a checkbox for limiting the minimal symbol rate, with a field for manual inputting a SR value, separate for DVB-s and DVB-S2, so the transponder with lesser value shall not be scanned?
This would be a generic solution for any similar problem on any hardware with BDA support.
Thank you,
Marius
I traced the problem back to the fact that the symbol rate is to small for some transponders for the given hardware.
Removing these transponders solves the problem (somewhere around 3500kS/s).
Now my proposal: In the BDA properties dialog in TV sources, is it possible to have a checkbox for limiting the minimal symbol rate, with a field for manual inputting a SR value, separate for DVB-s and DVB-S2, so the transponder with lesser value shall not be scanned?
This would be a generic solution for any similar problem on any hardware with BDA support.
Thank you,
Marius