Page 1 of 1

Skystar HD suport for motor dish

Posted: Wed Feb 14, 2007 6:59 pm
by jermaine
Hi, i have a dish with a motor, controled by a positioner.
It works with skystar hd and progdvb?

Thanks

Posted: Wed Feb 14, 2007 10:43 pm
by Juergen
How's that positioner controlled, to switch / drive from one bird to another?
If not by DiSEqC commands, no way, sorry.
You would have to move manually in any other case, and hope, the DVB software won't cause trouble while signal's not available.
Disable 'refresh channel if lost signal' then, at least.
And make sure to use a codec (& renderer), that's not causing trouble on signal loss.