Page 1 of 1

No 22 Khz switching with Hauppauge Nova SE2 / S+

Posted: Sat Jan 03, 2015 9:48 pm
by mad_marty
I use a Hauppauge Nova-se2 Tv-card in my pc and I seem to get only channels below a frequency of 12050 Mhz in H and V polarisation. I use Astra 19.2° East and a digital single LNB from Technisat.
I tried find some answer with google and it seems my tv-card doesn't switch to highband?
Is this correct? I read somewhere that Hauppauge cards might have a problem with the 22khz signal to switch to the Highband but I found no proper solution so far.
Did somebody had a similar problem? What can I do to check this?

Re: No 22 Khz switching with Hauppauge Nova SE2 / S+

Posted: Sun Jan 04, 2015 7:39 am
by Prog
Do you have any diseq devices?

Re: No 22 Khz switching with Hauppauge Nova SE2 / S+

Posted: Mon Jan 05, 2015 10:35 pm
by mad_marty
no, just a single lnb, directly connected to the tv-card.

Re: No 22 Khz switching with Hauppauge Nova SE2 / S+

Posted: Tue Jan 06, 2015 6:23 am
by Prog
I am not have good idea about ProgDVB side. But check LNB type and switch value.

ps: Is it BDA?

Re: No 22 Khz switching with Hauppauge Nova SE2 / S+

Posted: Wed Jan 07, 2015 4:53 pm
by mad_marty
In ProgDVB it is shown as DBA. I installed the standard Hauppauge driver.
Is there something like a test-software, so I might check if the 22khz signal is working?
I will try another tv-card soon.

Re: No 22 Khz switching with Hauppauge Nova SE2 / S+

Posted: Wed Jan 07, 2015 5:11 pm
by Prog
I have ProgFinder, but recommend use other software for test.

ps: You problem looks like hardware or in driver...