Display posts from previous
Sort by

Radio channels no sound with Progdvb 5.11.2

#1 by edc
I have latest progdvb and Vista x64. Video channels work normaly with sound but when i switch to radio there is no sound. Radio channels show signal strength but no sound. Same audio decoder (elecard audio decoder) is used for both video and radio. It seems that there isn't data stream, bit rate shows 0 Kbps.

#2 by Juergen
This may depend on either the audio decoder and splitter used, or on Vista, which should stil be called an early beta version, from my point of view...

Perhaps try to use anther codec for radio only, maybe with a custom made graph.
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!


I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!

1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>

#3 by edc
Thanks on reply, i tried other codec and custom made filtergraph but nothing, still no sound. With previous version (5.11.01 i think) i had sound, wich leads me to think that problem is in this version.