LNB Change too slow

#1
Hi

I`ve got two Problems :((

Astra 19,2 and Hotbird 13

When I use BDA 5.0.0.6 driver (newest) for my Technotrend S2-3200 at ProgDvb 4.85.3 on WinXP Media 2005 everything works fine. Only the Change of the LNB is too slow, I have to click on a channel from another LNB a second time after some seconds to provide it. Channel-Change at the same LNB works with one klick without a problem.

When I use BDA 4.0.0.18 driver everything works better, but only one LNB (Hotbird) can be found. Don`t know why. other people havent got this problem :((

Can someone Help me, please?

#3
DiSEqC control needs some extra time, but normally this should not exceed half a second.
Try to play with the 'distinguished by' settings, there are just four possible combinations.
If this won't help, try to activate option 'refresh channel if lost signal'. By this ProgDVB will repeat the procedure automatically if failed.
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>