progdvb.com

After installing my hdd´s in new hardware (old HP xw4600 new HP Z210) both systems did a lot of updates because of chipset, videocard and so on.
after running w7 ultimate (x86) and w10 prof (x64), i have the following problems.
Viewing normal channels is a little bit garbeld, but HD-channels are without sound and the video is very destroid (unvieable).
Within w10 the problem ist much bigger. Old card nvidea fx380, new nvidea 210.
i tried the following:
1 remove all videodrivers
2 reinstall all videodrivers
3 installing the software delivered with my card (techno-trend S2-3200) and there it works.

But the tt-software is very simple so i´m looking for a way to use progdvb like the last 7 years.

Usually not depended from video driver. Only from DVB driver, possible from video codec. But check File->Input->Traffic->Packet lost at first.
Also you can check Options->[device name] -> mode and of course use ProgDVB x32 (not x64)

On W7 (x86) i always use the 32-bit version on W10 (x64) i always use the 64-bit version of progdvb. It is a dual boot system, i can only run one at a time.

But check File->Input->Traffic->Packet lost at first and where can i find it? i did nothing on progdvb after installing the hd´s in new hardware.

I found it. At normal channels it looks like this min lost 3 384 (0.1%) in HD-Channels i cant see it because it is flickering with no response in the headline.

is it possible check value on HD channels? You can disable playback of channels on first page of settings for stable working on bad traffic.

Without playback there are 0,0% loss. For example i put a snapshot hoow HD-channels are on this reply.

What value with playback? What video codec?

With playback the window with values about transfers and loss will be still clear (no pattern). Videocodecs i put all to standard.

What standard? Try other codec for this video type.

Whicht one ?

for MPEG-2
H.264/AVC
WMV
MPEG43
MPEG4a

You can look in channel properties or in OSD channel info window. Usually h264

I have set H.264/AVC to the corresponding codec, also the next three, i`m actually experimenting with the first MEPG2.

I have taken a screenshot with my actual video codec setting.
What is wrong for viewing HD ?

You can try other codec for h.264. For example install LAV or select Microsft. Of course if this h.264 channel

Where can i download LAV, i have only this one and one other codec in this dropdown menue.