Cablestar 2 TV - finding no channels

#1
Hello!

I m using in my Flat a DVB-C receiver (technotrend) for my TV, connected it an he found a lot of channels (works well). The signal comes form a "headstation" (wich is connected to a satelite receiver i think).

Now i bought a Technistar (cablestar 2 TV) an used prog DVB, but i cant find any channels, with the software from technistar its the same problem.
Seach runs, takes a lot of time and at the end no channels found... but vor example on my TV receiver i can see that on (322000, 64 quam, 6875) is a channel...


would be really glad if somebody has any ideas!


Greetz Tim

#2
Try to scan a transponder manually, using the same parameters that are working on your TV receiver.

Perhaps you will have to create your own transponder list for full scanning, as most probably the values are non standard in your situation.

Editor rulez...
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>