technotrend s2-3200 remote control
Posted: Sun May 27, 2007 5:00 pm
is there a way to use the remote control of s-3200 technotrend card ? pls msg 
progdvb.com
technotrend s2-3200 remote control
Page 1 of 1
Posted: Sun May 27, 2007 11:09 pm
I got the same problem. Is there a module for the TT remote control?
Posted: Mon May 28, 2007 11:17 pm
Allow me a question (as I don't have that card):
What device file is used for it?
What device file is used for it?
Posted: Tue May 29, 2007 5:04 pm
BDA device Technotrend
Posted: Tue May 29, 2007 9:51 pm
Semms to me, that device does not support the original remote port.
If in doubt, look into the device list again and mark that device, to get it's features listed.
Perhaps the original software uses some proprietary tricks to connect ot it.
AFAIK a chipset integrated IR port is not supported by the MS defined BDA architecture.
Prog would need a fully working SDK, to analyze and implement things like this, no idea, if that's available.
If in doubt, look into the device list again and mark that device, to get it's features listed.
Perhaps the original software uses some proprietary tricks to connect ot it.
AFAIK a chipset integrated IR port is not supported by the MS defined BDA architecture.
Prog would need a fully working SDK, to analyze and implement things like this, no idea, if that's available.
Posted: Thu May 31, 2007 5:37 pm
indeed, the remote control feature does not appear in the device list.
Too bad.
Anyway, thanks for your help Juergen.
Too bad.
Anyway, thanks for your help Juergen.
Posted: Thu May 31, 2007 10:59 pm
Still a chance, to try to go the Lirc way.
You would need a serial port IR adaptor then, as mentioned many times before.
BTW, do you have the chance, to test your remote on a Philips (comaptible) TV set?
Or try a universal remote, if it works on the original application, in any of the Philips TV codes and basic functions (like Mute, Vol +/-, Power Off).
As I did not yet have such a card in my hands, I'd like to find out, if it's still the same thing as on the SS1.
You would need a serial port IR adaptor then, as mentioned many times before.
BTW, do you have the chance, to test your remote on a Philips (comaptible) TV set?
Or try a universal remote, if it works on the original application, in any of the Philips TV codes and basic functions (like Mute, Vol +/-, Power Off).
As I did not yet have such a card in my hands, I'd like to find out, if it's still the same thing as on the SS1.