Page 1 of 1
please heeeeelp!! about dm1105 dvb-s
Posted: Sun Dec 23, 2007 5:55 am
by dr.davinci
although every thing is okay,THE DEVICE NOT STARTED
WHAT CAN I DO?
plsssss heeeelp
Posted: Sun Dec 23, 2007 3:36 pm
by Juergen
WHAT device, exactly?
If your hardware uses BDA drivers, you'd either need the tuning space registry entries or the original application installed and set up completely first.
Posted: Mon Mar 17, 2008 9:45 pm
by Ahmad_k
i have the same problem, i have an ePRO DVB-s reveiver but i think it dosn't use a BDA driver. When i open the device manager it use DM1105CAP driver file. is this card supported by ProgDVB ?
Posted: Mon Mar 17, 2008 11:45 pm
by Juergen
Just ry, if you can find a suitable device from within ProgDVB --> device list.
If there's a BDA device with a suitable name to be found, you do in fact have a BDA driven and (more or less) compatible device.
But if only finding general BDA devices, you don't.
That's the exact device name I'd really like to know from you both...
Posted: Tue Mar 18, 2008 6:24 am
by Ahmad_k
No there is no BDA device in the List. it show me {BDA}No device
I have tried the newmi DM1105.device found in this website, but i have a problem. When i select this device from the list the program runs ok. but when i need to scan channel on selected satellite, PROGDVB show me the level signal and then freeze. I have tried this on windows vista and the same happen
Posted: Tue Mar 18, 2008 1:54 pm
by Juergen
Well, obviously it's NOT a BDA driver.
This for, the device file in use must suit the hardware perfectly. And therefore the only one who may be able to help any further should be Prog himself...
Posted: Fri Mar 28, 2008 5:56 pm
by Ahmad_k
Hello again, my problem is solved after i try newmi module from this website. But a strange problem exist. the card work very good on the pro version, when the trial expired i switched back to standard edition and now only the quality and level are shown and there is no picture. I tried to reinstall codec but with no success. anyone have an idea ?
Posted: Fri Mar 28, 2008 8:24 pm
by Juergen
Maybe you have to re-register / -adjust your codecs.
Posted: Sat Mar 29, 2008 5:27 am
by Ahmad_k
How can i do that ?
.
Posted: Sat Mar 29, 2008 8:07 am
by Prog
btw in last ProgDVB updated newmi module. You can test it also.
Posted: Sat Mar 29, 2008 11:31 am
by Juergen
register codec(s):
look into the file 'register.bat', edit to your needs, run.
edit codec properties :
run ProgDVB with it --> file --> properties ...
Posted: Sat Mar 29, 2008 12:57 pm
by Ahmad_k
When using the new newmi module in the last version, ProgDVB crash when enabling the devie, and i have a registered version of Elecard but nothing happen. Is there any serial to extend the trial for only 1 day ? I only need to retest my hardware on the pro version again to know from where the problem exist, from codec or from the standard version.