progdvb.com

Is it possible to set the Channel to NONE?
Just like when ProgDVB open/run ( if "set last channel" is OFF).

Except of a .bat driven dirty trick, exchanging ProgDVB.ini, no idea.
What do you need this for, exactly?

What do you need this for, exactly?

I've got 2 DVB cards on each of me computers, when i open the First one if i set a channel i can't open the second DVB card, both two ProgDVBs just stuck and i get no responce. To open both of them i must open one by one, first the "card1" ProgDVB and when it all load ("set last channel" is off) i open the secont one "card2" ProgDVB.

Thank you.

I see...

Do you have an idea on the source of this conflict, like perhaps video overlay?
HW or SW mode?

No idea, if Prob would like to implement a command line switch, to start without a channel selected.

However, perhaps you can try to start ProgDVB with playing a short file, somehow.
May be different on older versions, that still support HW playback (<= 4.84.1).

I think it good idea for implementation...

Prog wrote:I think it good idea for implementation...

Very nice news Thank you.

like perhaps video overlay?

Maybe video overlay, but what about Radio Channels?

HW or SW mode?

In Hardware Mode

I just tried to give you hints on what to test on.
So, does that collision also happen, if both cards are set to radio stations at start?
Or if at least one of them is set to surface mode?
Does this also happen, if one or both of the cards is / are using an engine1 version of ProgDVB?

BTW, do they have different physical PCI INTs ~ interrupts (below 16)?

Perhaps we can get a bit closer to the source of this problem, somehow.
Here I don't have a second SS1 to test with. But basically, two video overlays at the same time are OK on my system. The Nexus and my good old FAST AVMaster are working fine together (on Win9x, as the AVMaster only has VxD drivers available).

A last question, just for being curious:
You are listing ten positions. Are all of them available for every device, by a big DiSEqC solution, means, do you access more than four positions from one tuner?

You are listing ten positions. Are all of them available for every device, by a big DiSEqC solution, means, do you access more than four positions from one tuner?

I have Four on each of my device. (i don't think they work more than four, only with 12v swicher)

So, does that collision also happen, if both cards are set to radio stations at start?

Yes it hapens with radio.

Or if at least one of them is set to surface mode?
Does this also happen, if one or both of the cards is / are using an engine1 version of ProgDVB?

I have one at "sureface + Bob mode" and one at "Overlay +Software Scaling" ( or "sureface + Software Scaling" and one at "Overlay +Bob mode" ) if some thing else then i have a mush up in picture and i can't see a think (i need to reboot to fix it).


I noticed twat if i have disable the "Direct Draw" (progdvb4xx) then i have no preblem (but olso no picture at my pc)


Thank you.

Just another wild guess...
VGA driver issues?

Else I am running out of ideas

Fixed!!!!! I don't know From what Version but IT WORKS!!!
Thank you Prog!!!


Now.(5.13.09)..if I have at my ProgDVB(1) one channel Running (any channel, Radio or Video) and my ProgDVB(2) is closed I Can Open It (the ProgDVB2) Without close the ProgDVB(1), (as I used to do).
Yesssss Now I can open then, at any time i Want, not at the sametime!!!

Thanks!!!!