progdvb.com

Hi,

is there a way to have DVB-S and DVB-T enabled together in progdvb? Because here i can receive different things on DVB-T and DVB-S so i really would like to switch between them dynamically.

But the only way i found is to disable one of the BDA devices in the device list and enable the other (which is kinda frustrating).

Can i bind specific channels to specific devices and have them enabled as needed?

Thanks

Yes, you can enable both devices (in free version also). But I am not test this function on 4000. It can be depended from hardware and driver.

Hi,

i doesn't seem to work, i got 4 devices in my device list

{BDA} Hauppauge WinTV 88x DVB-T Tuner/Demod
and
{BDA} Hauppauge WinTV 88x DVB-S/S2 Tuner/Demod

On time with File Name anysee.Device and another time with BDA.Device

The anysee.Device doesn't seem to work anyway, from the BDA.Device it seems i can enable one alone just fine.
But when i try to activate both, i get the error: "Run DBA graph error", and then Device not started (with the name of the device i try to start).
The device then has a card symbol with an X.

So it seems only one at a time works.

Same thing here with HVR-3000.

anysee devices doesn't work at all, and BDA devices I can enable only one at a time.
Is it because this is hybrid card, or poor BDA drivers?

And still no Hauppauge remote support....

You must use BDA.device.

OK, I am using BDA.device, but why I can't use both DVB-s and DVB-t devices??
When I select one, second is disabled. Is this because card is hybrid?

Few weeks ago I asked about IR support for Hauppauge...
Is there any progress with this piece of your fabulous software??

This this _hardware_ not support two tuners at once.

PS: Sorry in this month I was busy by other part of ProgDVB.