Page 1 of 1
Technisat Skystar HD2 CI-Slot with Cryptoworks and ORF-Card
Posted: Fri Jan 08, 2010 8:20 pm
by sarge
I bought a CI-Slot for my Technisat Skystar HD2 (BDA-Driver).
I plugged a Cryptoworks Module with ORF-Card in it.
I activated the Cam-Interface in ProgDVB.
If i click Options - Cam-Interface, it says "Waiting for Data ...", but no Data appears (i waited for 1 hour).
Wot´s on Prog, how can i make it working ?
I use the latest ProgDVB 6.30.03
Posted: Fri Jan 08, 2010 10:09 pm
by Juergen
Try to select the cryptoworks related ECM as default in ProgDVB channel properties.
AFAIK this should be identified as CA-type 0xD05 for ORF.
Switch channel back and forth then.
If working, set channel props to not update.
BTW, CAM operation may be hardware depending. In case you may have to check device settings, IF ProgDVB's device supports CI / CAM controls on that tuner (already).
.
Posted: Fri Jan 08, 2010 10:09 pm
by Prog
CI can not work on some devices. But channel must be work.
Kanaleigenschaften
Posted: Sat Jan 09, 2010 9:11 am
by sarge
Lieber Jürgen !
Bei den Kanaleigenschaften (CAM) ist ja Cryptoworks an erster Stelle.
Da kann ich nichts umstellen oder als Default wählen.
Posted: Sat Jan 09, 2010 9:51 am
by SiLencer
Hi , try reading the boardrulez !
The Board language of the international section is English !!!
Decoding of ORF under DVB-Viewer works, under ProgDVB sucks
Posted: Sat Jan 09, 2010 7:12 pm
by sarge
Why decoding of ORF under DVB-Viewer TE2 works but under ProgDVB sucks ?
I use the Technisat Skystar HD2 CI-Slot and the Technisat CW Ci-Module with a new ORF-Smartcard.
My OS is Windows 7 x64 Professional.
Posted: Sun Jan 10, 2010 10:39 pm
by Juergen
At least on older versions of ProgDVB (did not test the recent ones for that), you could double click an ECM entry in channel properties, to transfer it to the ECM ID field, which would make it default.