Display posts from previous
Sort by

Device not started

#1 by green monkey
Hello,

I want to start ProgDVB 5.15.11 on vista 64 with Pinnacle pci pro 450i, but I get the message: device not started (BDA) no device. I have installed: Standard edition /x64. Do I need any driver for the card? Now Stargate drivers /64 are installed, but there is a problem, because it can't be loaded. If I try it a new one, the system says, the driver is already installed.
Please can you help me. Hope you did understand my english! :lol:

cu

:cry: :cry: :cry:

#4 by Juergen
Perhaps install the 32 bit drivers first.
Technically it's 32 bit hardware anyway.
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!


I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!

1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>