Hi all,
yesterday I have bought a new PC. It is a Microstar (Medion) with Pinnacle PCTV 7010iX DVB-S/DVB-T card. I installed ProgDVB 6.01 and everything works fine, except 12.692H. On this transponder signal quality is zero. 12.699V works fine! I tried another satellite receiver and 12.692 showed signal quality 95%.
Any ideas?
Thorsten.
#2
That transponder works fine here.
Try to fine tune the frequency, in small steps up to +/-5 MHz.
If working, don't store, but change the LOF used, for the offset found, into the opposite direction.
Check your dish alignment carefully, as exactly the same frequency is also used on Hotbird 13°E, with same polarisation, but different symbol rate 27500.
Also check LNB skew / tilt, to reduce cross talk from the other polarisation.
If being pretty close to any limit, what way ever, every other little suboptimal issue might make things fail in the end.
BTW, do you have the same problem with any other software or ProgDVB version?
Try to fine tune the frequency, in small steps up to +/-5 MHz.
If working, don't store, but change the LOF used, for the offset found, into the opposite direction.
Check your dish alignment carefully, as exactly the same frequency is also used on Hotbird 13°E, with same polarisation, but different symbol rate 27500.
Also check LNB skew / tilt, to reduce cross talk from the other polarisation.
If being pretty close to any limit, what way ever, every other little suboptimal issue might make things fail in the end.
BTW, do you have the same problem with any other software or ProgDVB version?
My signature:
Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>
Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>
#3
I tried it with an other software and the problem remains the same. Therefore I assume, that the problem is not caused by ProgDVB. All other transponders at the high end (e.g. 12.663H) work fine with signal quality equal 100%.
I tried also an other satellite receiver, no problems with ORF transponder
Because having actually no time, I will try further options next weekend.
Thorsten.
I tried also an other satellite receiver, no problems with ORF transponder
Because having actually no time, I will try further options next weekend.
Thorsten.