#3
by Juergen
First of all, the driver matters, if it's WDM or BDA.
If I remember well, BDA module did NOT support DiSEqC in that days.
So in case use the normal WDM driver, or you had in fact to go for a modern version of ProgDVB.
Also the latest hardware revision of the SS2 may require a more modern version of ProgDVB.
Well, you did not tell us your hardware revision...
Anyway...
DiSEqC still is the same.
And LNB technology also did not change.
Just the transponder tables inside of ProgDVB are not really up-to-date.
But those can be edited or exchanged, to not miss anything (possible).
This was discussed here many times.
If it really is an old SS2, your tuner hardware does not receive DVB-S2, so you don't need to have that transponders listed.
Regarding LNB parameters, i.e. LOFs and switch value, default is correct for Ku band in Europe.
And position switching must reproduce your hardware setup.
If you are using three LNBs on a four port DiSEqC switch, set DiSEqC 1.0 controls according to that. First to last port (used) on the switch means top to bottom on the dialogue.
Actually we can't know, where your first, second and third (or fourth?) LNB actually point to. Surely you do...
My signature:
Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>
Can someone explain how to set up LNB by frequency and all necessary parameters.