Skystar 2 pci + DiSEqC 1,0 + LAV filters

e1iminator

Skystar 2 pci + DiSEqC 1,0 + LAV filters

#1 by e1iminator

hi,

it just doesn't work. i can't switch channels between satellites. i have to restart the application or change renderer to switch. can you make progdvb use LAV splitter/demuxer directly?

thanks

i use an nvidia card

Last edited by e1iminator on Sun Feb 05, 2012 2:34 pm, edited 1 time in total.

Re: Skystar 2 pci + DiSEqC 1,0 + LAV filters

#2 by Prog

ProgDVB not support LAV splitter/demuxer (I am not sure about Push demux in this filters pack). But what problem with Prog Demux?

e1iminator

Re: Skystar 2 pci + DiSEqC 1,0 + LAV filters

#3 by e1iminator

the same. i cannot change channels between satellites

Re: Skystar 2 pci + DiSEqC 1,0 + LAV filters

#4 by Prog

Settings for diseq in Settings->Options. It is not depended from demux and filters.

ps: Also you can try change driver to BDA or to WDM

e1iminator

Re: Skystar 2 pci + DiSEqC 1,0 + LAV filters

#5 by e1iminator

i use WDM BDA doesn't work at all. when i change renderer like from EVR to renderless channel displays. i change again to other satellite channel. no channel displays