progdvb.com

I am not like change API for _ONE_ DVB card and for _ONE_ transponder.
hauppauge promisse me in mail autodetect some transponder parameters.

"but why is the 11914 s2 transponder working on latest dvbviewer ?? "
but shy no any problem with all other cards ?

sorry for my bad english, but what do you mean with your last sentence ?

Main difference of the non working transponder seems to be FEC 9/10 (instead of e.g. 2/3 on the other DVB-S2).

This may be driver related, indeed.
Some third party software may already know a trick, to bypass driver limitations then.

Last sentence surely should have been like 'but why no...'

lets hope for Prog's magic nova s2 scan fix in the next release

Hallo,

I have now 2 Hauppauge WinTV Nova HD-S2 and it's working (;

I can view 2 channels in the same time. On the top is a Tab, where i can switch between TV1, TV2 and Both.

But there is my problem. The mode "Both" do have only the mode table and icons.
The 2 pictures are always site by site. No Picture IN Picture.
Will this mode implemented in future?
Or is there a general restriction?

What main difference between "icons" and "Picture IN Picture" for you?

Normally PiP means, one picture has full size, and a second one (downscaled to a smaller size) is inserted into it, e.g. on the right low corner, covering that part of the big picture. May even be outside of the big picture, if that is 4:3 on a wide screen, and one or more small picture(s) added on the unused side area(s).

Pictures of the same (reduced or cropped) size, side by side, would be called mosaique mode.

It is not big differens for PC.
1. Ratio of monitor in 50% not same like ratio of TV and you have space in any case.
2. IN PIP on PC (in ProgDVB) you can open more then two window at once. I test ProgDVB on 4-9 channels in one time.