Page 1 of 1

Switch funktioniert nicht?

Posted: Sat Mar 11, 2017 12:00 pm
by murata
Hallo,
ich habe das Programm ProgDVBProf. installiert und aktiviert per Schlüssel.

System: Win7Prof.x64
LNB : Türksat 42° und Astra 19° über Switch 22KHz
Tv-Karte : KNC1 TV-Star

Genau so auch bei Quellen eingestellt.

Bei Pos1 Türksat und Pos2 Astra:
Findet er paar 70 Kanäle bei Türksat also nicht alle... (TRT kanäle und paar NoNames)
und bei Astra auch paar Türksat Kanäle ...?
Sehe auch das bei beiden die TransponderAnzahl die selbe ist. (131)

Bei Pos1 Astra und Pos2 Türksat:
findet er garnix..
__
Gibt es irgendwo ne funktion zum Update oder richtig stellen der Transponder?
Oder was ist hier wohl der Fehler?
___

Ich hatte von irgendwo eine ältere 21 Tage Prof. Version bei der er alles angezeigt hatte... also TürkSat fast alle Sender und Astra auch ausser DVB-S2 da Karte nur DVB-S!
___
Image

___
Edit: Ich sehe am Foto das es ein Disecq 4 Schalter ist und ich nicht 2 Port Switsch sondern den Diesq nehmen sollte bei den Einstellungen!? Ich werde es mit der Einstellung veruchen wenn ich Zeit habe und mich wieder melden!

Re: Switch funktioniert nicht?

Posted: Sat Mar 11, 2017 3:24 pm
by Prog
Try change mode in Options->[device name]->mode

Re: Switch funktioniert nicht?

Posted: Sat Mar 11, 2017 5:33 pm
by murata
Haven't found what you mean?

Re: Switch funktioniert nicht?

Posted: Sun Mar 12, 2017 3:29 am
by Prog
Yes, but may be microsoft is best mode. Also some very depended from cable and switch.

Re: Switch funktioniert nicht?

Posted: Sun Mar 12, 2017 3:28 pm
by murata
ok i have changed to Diseq and at the first search for channels it has founded i think all TürkSat Channels but no Astra Channels.

Later i have retried to find Astra Channels and let searching for it and it has found the Astra Channels also...

my first failure was to not choose Diseq and to choose Switch 22KHz!

at the moment everything is fine and if i will have any problem or question i will write it at the english section!

bye