progdvb.com

well

if i let progdvb run with Soft mode the sound is avaible, but if i work while progdvb is running the picture is bad.

if i try to switch to Hard Mode i get some problems:

1st: the picture is zoomed in ... i mean the picture is maybe only to 95% avaible .. the other 5% are outside of the progdvb boarder.

2st: the sound is not avaible. i tried to select in "audio and video/Options" at Volume control Sat TV Card or SB Card/Line In there is no difference between the selections - i dont have sound.

i had to install windows last week .... before this all worked fine

PC:

CPU: XP 3200+
RAM: 1,5 GB DDRAM
Video Card6800 GT
TV Card: Techno Trend Premium ( Nexus-S )

Drivers:
TV Card: tt-premium_219c_pcie
Video Card: 93.71_forceware_winxp2k_international_whql

ProgDVB v. 4.62.6
( 4.84.2 tested - same problem )


does anyone have some solutions?

1st: the picture is zoomed in ... i mean the picture is maybe only to 95% avaible .. the other 5% are outside of the progdvb boarder.

Try 2.19 driver without ´c´

2st: the sound is not avaible. i tried to select in "audio and video/Options" at Volume control Sat TV Card or SB Card/Line In there is no difference between the selections - i dont have sound.

Check your cable from the nexus to your sound card and switch on the ´line in´ of your soundcard (where the cable from the nexus goes in)

2.19 worked ... thx ... the both problems are gone .. but next problem is now there

i use 2 monitors, on the primary monitor the picture is ok ... but if i move the window to the second monitor ... the picture is gone, sound is avaible. progdvb show only a dark blue screen in the frame where the normal picture should be


and how to fix the problem: in soft mode i dont have the OSD-Menu

Try other renderer in : settings->Audio/Video->Direktshow (e.g. vmr 9)...

the ´monitor problem´ maybe depends on the settings of your video card...(driver settings...)

Many dual head VGA cards don't support overlay on secondary monitor.
This for, in HW mode, either use surface (select in device options), or have the other monitor set to be primary display, by your VGA card driver controls. Read your VGA manual for more, f.e. regarding Theatre Mode, cloning and alike.

In SW mode, OSD depends on codec / graph / renderer.