progdvb.com

Hi guys,

I downloaded the latest progdvb installed and try to setup LNB under DiSeqC but there is not green or gray dots infect there is nothing at all except the card name. Could someone please help me with this?

Here's my setup.

Win XP
DVB-S 100 card from KWorld
ProgDVB 5.x

When I click on Settings --> Device List I can see the card and I have enabled/started it. Than I click on Settings --> DiSeqC I only see the card name but no green or gray dot to configure. On the side I see the option to add LNB but when I click on it nothing happens. Please help.

Don't have your device, nor any 5.x version of ProgDVB running right now.

Does the original software package work, that came with your hardware?
It's always a good idea, to get that running first.

If your device uses BDA drivers, instead of normal WDM ones, it's possible, ProgDVB does not provide DiSEqC on it.
What do the comments tell, that are visible if the device is marked in the device list?


When using DiSEqC, you have to select the DiSEqC mode and then add the switch first, afterwards add LNBs to it's ports and set their properties.