progdvb.com

I've got a little problem, i tried the new version of ProgDVB 5.11.08pro for this :

" 5.11.8[Pro] Now you can open more one channel from same transponder at once by Alt+Click. "

but i can't make work.
I go to same transponder and I alt+click channel but i've got nothing, only one channel works, and when i alt+click on channel i can't click other channel it just don't work.

It is impossible on nexus. This function request TS and more 8 filters.

Prog wrote:This function request TS and more 8 filters.

Thanks.
But what is the "TS", and what 8 filters?? Where can i find it?

Near any other card exclude nexus, dec300, twinhan 7021.

It is impossible on nexus. This function request TS and more 8 filters.

Prog wrote:Near any other card exclude nexus, dec300, twinhan 7021.

Is This possible on Hauppage DVBs ? or it's the same with nexus?

I am not know. Hauppauge can have cards like nexus. But all modern Hauppauge cards good this mode.

This is about hardware limitations of the SS1 / Premium concept based cards, that come with a DSP and TV out.

Those cards are alwys using hardware stream filtering, even in software mode, and their HW filters are limited by number and most of those only have a single or fixed output.

Due to this, they don't provide full transport stream (TS).

All other DVB devices ONLY deliver transport stream and leave all the filtering to the software used.

Hauppauge Nexus cards are made by Technotrend, and they are almost identical with TT branded versions or even a couple of other older OEM varieties.


Never seen the DEC300 or Twinhan7021 Prog mentioned.
But the cause may be similar.

Thanks.