progdvb.com

Hi,
I have just bought a TechnoTrend 3650 and I am very pleased with the ProgDVB support - worked first time. Can anybody tell me how I enable the CI support with 4.83? Do I need any additional files / versions. BTW the standard (bag od Bolts) software works with the CI interface but is a pain to use.

Any help greatly appreciated.

Regards

Kite

You must install last version and select technotrend in device -> options

Hi Prog,

The version of the driver that I have is 1.0.2.11 and is dated 28/9/2007 - this is the one of the Technotrend site. Is this the right one? If I go into device->options and select TechnoTrend, exit and restart it comes up with anysee not Technotrend. Not sure what I'm doing wrong

Regards

Kite

Hi,

If anybody has this working can you please reply to this post and I can then compare notes.

Regards

Kite

I have similar problem. I have a TechnoTrend TT-budget S2-3200 with the latest BDA driver installed on Vista 64 bit. I downloaded the latest version of ProgDVB (5.12.04).

In the changelog, it says "5.12 Support CI for technotrend BDA the driver (3200, 3650), ".. however I can't use the CI.

When I open the Settings >> CAM Interface, the popup window tells me "Waiting data..." but nothing happens. The Settings >> Device Options tells me "Auto [unknown]".. When I set it to "TechnoTrend", then exit and restart the application, it sets itself to "anysee".

The "Enable CAM interface" option is checked in the Options.

It seems I have similar problems than kiteb.. Any suggestions?

Ok, found the solution:

Settings >> Device list..

Select "{BDA} TechnoTrend.. blabla // anysee.Device" then "Disable". Select "{BDA} TechnoTrend.. blabla // BDA.Device" then "Enable".

Now you can configure and select your CI.

Quick Update... Reinstalled Vista and installed latest ProgDVB and the CAM is now accessible.

Thanks

Kite