progdvb.com

I've used Prog in the past, but haven't for more than a year since I got a new motherboard. Now I can't get Prog to work. My 4_88_9 installation picked up only a few channels when I scanned 110 and 119 (2400 and 2510 in the transponder ini files). I tried rescanning, scanning individual transponders, then deleting all channels and scanning again. Now I don't get a single channel, and the level indicator stays low (but not zero) while the quality indicator stays zero. As far as I know, my diseqc is in the 1.0-2.0 type, though I did try the other settings. My card starts without error and it looks correct from the device menu. I have two Nexus-s's (2.3) and I've tried starting and scanning both. I've rebooted before retrying some of these operations, but still scanning doesn't give a single channel. These same Nexuses work with MT just fine, so I know my system is functional.

So I tried installing 5_12_9, but every time I launch it, it quits with the error "The application failed to initialize properly (0x0000135)."

Any suggestions how to troubleshoot either version 4 or 5?

What last good version for you?

"The application failed to initialize properly (0x0000135)."
You not have net framework on PC.

Prog wrote:What last good version for you?

"The application failed to initialize properly (0x0000135)."
You not have net framework on PC.

OK, I see I had my scan range set incorrectly. 4_88_9 is now scanning.

Thanks for the info about version 5. I looked around the web site and documentation and could not tell what was different about version 5, so I didn't know about it needing .NET framework. Is there someplace where the version 5 features are documented?

You can install and try it

Requirement for .NET is mentioned right on top of the 5.x download page.
This is the most important aspect of it.
Reading is a virtue...