progdvb.com

Hauppauge HVR-4000 is missing transponders if I run "Channel search" and use "DiSEqC 1.0 or 2.0" I can manual add the missing transponder with "Scan Transponder"

I have attached a video to help troubleshoot the problem
http://www.2shared.com/file/2960821/5f1 ... rScan.html

Any ideas?
Thanks

--------------------------------------------

Scan log "Channel Search" (Progdvb 4.89.8 )

[SATTYPE]
1=3592
2=Thor 2/3, Intelsat 10-02 (Telenor)(1°W)

[DVB]
0=25
1=11216,V,24500,78,DVB-S Failed
2=11229,H,24500,78,DVB-S OK
3=11247,V,24500,78,DVB-S OK
4=11261,H,24500,78,DVB-S OK
5=11278,V,24500,78,DVB-S Failed
6=11293,H,24500,78,DVB-S OK
7=11309,V,24500,78,DVB-S Failed
8=11325,H,24500,78,DVB-S Failed
9=11341,V,25000,23,S2 OK
10=11357,H,24500,78,DVB-S OK
11=11372,V,24500,78,DVB-S OK
12=11389,H,24500,78,DVB-S OK
13=11403,V,24500,78,DVB-S Failed
14=11421,H,25000,23,S2 OK
15=11434,V,25000,23,S2 Ok
16=11823,H,28000,78,DVB-S Failed
17=12054,H,28000,34,DVB-S Failed
18=12169,H,28000,78,DVB-S Failed
19=12226,V,28000,34,DVB-S Failed
20=12303,V,27800,34,DVB-S Failed
21=12322,H,27800,34,DVB-S Failed
22=12399,H,28000,78,DVB-S Failed
23=12456,V,28000,34,DVB-S Failed
24=12476,H,27800,34,DVB-S Failed
25=12520,V,17500,34,DVB-S Failed

Perhaps your 22 kHz band switching does not work, as you don't get anything above the default switch frequency.

Band and pola switchiung are NOT subject of a possible switch to be registered in diSEqC / LNB settings, but LNB internal components.

Regarding the few low band transponders you are also missing, how are L & Q for their neighbours?
Also possible, your LNB's LOFs do have a little offset.
To disciover and specify such, try to detune a working transponder, to find an offset of the transponder center frequency. If a systematical exists (for a band), change the LOF for that amount into the opposite direction.