Page 1 of 1
All of a Sudden ProgDVB keeps crashing :(
Posted: Thu May 01, 2008 10:00 am
by thehoff
hi, i have a strange problem.
yesterday progdvb went fine, but today i started and i had nearly no L and Q. i couldnt find any channels anymore, the channels didnt work and when i tried to enter the direct show menu progdvb crashed. i have no clue what this is. i havent installed anything new.
any ideas?
i use progdvb 5.14.4 and a SS1 (cable)
Posted: Thu May 01, 2008 12:42 pm
by thehoff
Problemsignatur:
Problemereignisname: BEX
Anwendungsname: ProgDvbNet.exe
Anwendungsversion: 5.14.4.0
Anwendungszeitstempel: 4804ff2d
Fehlermodulname: StackHash_88e8
Fehlermodulversion: 0.0.0.0
Fehlermodulzeitstempel: 00000000
Ausnahmeoffset: 0414415b
Ausnahmecode: c0000005
Ausnahmedaten: 00000008
Betriebsystemversion: 6.0.6000.2.0.0.768.3
Gebietsschema-ID: 1031
Zusatzinformation 1: 88e8
Zusatzinformation 2: 990fc7823dfe659accc0fd9feab255ec
Zusatzinformation 3: 5a17
Zusatzinformation 4: 7a54e2ccff450d09a3ad06bd6187f454
Posted: Thu May 01, 2008 9:39 pm
by Juergen
What version of SS1, precisely?
Is it a Nexus / Premium card or a Twinhan clone SkyStar1 from Technisat, with no hardware decoder?
Posted: Thu May 01, 2008 10:24 pm
by thehoff
TT premium C-2300
i used it in SW because HW doesnt work on vista.
Posted: Fri May 02, 2008 11:52 am
by Juergen
To get closer to the source of your problem, try to delete the ProgDVB.ini and start again.
Posted: Fri May 02, 2008 5:24 pm
by thehoff
i de-installed and installed it several times. always the same problem.
Posted: Fri May 02, 2008 10:55 pm
by Juergen
Well, I suppose, you don't have any other DVB application to compare with, on Vista.
This means, apart from checking and reinstalling the driver (according to Technotrend without the networking component), I am running out of ideas.
p.s.
One last idea just occurred:
Try to disable mpeg2 decoder from timeshift window.
Of course, you can't get picture then, but this also means, no codec in use.
Scanning, EPG capture and recording should work even then, if receiving a valid signal.
If not even working without decoding, you would have to find another (Vista compatible) DVB application to compare and find out if only ProgDVB fails or you are having hardware issues.
Posted: Tue May 13, 2008 10:53 am
by thehoff
problem solved.
i switched to hardware mode and could entere de direct draw options. then i chose my filtergraphs and the renderer. after that i switched back to software mode. and i could enter the direct draw options again.
Posted: Tue May 13, 2008 11:00 am
by Juergen
Congratulations...
Now time has come, to make safety copies of all relevant files.