progdvb.com

Now I installed 5.15.07 but found then that I could not receive SAT1 any more. The programm show an error message and exits. Do not remember the text something with codec and audio. I returned to 5.15.06 and it worked again. So I am waiting for next version.

Is there a guide how to install a next release. I always make a copy of the tree and install the new version on the old tree. So I can easy switch back to the lat version.
But after the installation I always have to select the device and the satelit. There should be an easier update method.

I did not checked whether an automatic update of the pids in case of changing to local broadcasts is performed or not because I deinstalled the version immediatly after I detected the errenous channel.

Don't let write over the ProgDVB.ini, or make a backup copy before and replace by that afterwards.

What "SAT1" are you talking about, precisely?

What hardware and codecs do you use, what OS?

What audio mode(s)? AC3 would not use the same audio codec as standard MPEG audio.

And of course, the content of an error message is important to know.

Details rule.

read here : viewtopic.php?t=2949

The message was PIN connect error! Source->Cyberlink_Audio_Decoder.IN

Try AC3Filter

Switching "TV with AC3" to "Microsoft MPEG2 and AC3Filter" worked´. Thank you.

Today at 19:30 I tested wether the error disappear when the broadcasting switches to local transmissions. Nope, black screen and no audio as ever. I still have to reload PIDs.

Proplem still open in 5.16.09. Will there be a solution? Can I help with more details on the used Program/channel/hardware or is this problem recognized?