Page 1 of 1
problem with Technotrend TT premium s 2300
Posted: Sat Oct 04, 2008 9:41 pm
by maxmc
I have installed progdvb pro latest version. I had installed TT dirvers version 2.19h (special driver for pcie system form technotrend), when I run in HW mode the image is cutted on the sides, but it is ok when use software mode. The problem disappears with the normal driver 2.19c. How can I use the latest drivers avoiding this problem?
Thanks
Posted: Sat Oct 04, 2008 10:07 pm
by Talon
2.19c - the good for you.... 2.19h - only have PCIE support... but i dont know what that mean - i have pcie video card and use 2.19c - no problem
(with 2.19h - have same problem as you)
Posted: Sun Oct 05, 2008 5:46 pm
by Juergen
Where does this happen, on the computer screen or (also) on the hardware video out?
The PCI-e special driver DISABLES hardware mode for the computer screen picture, it FORCES software decoding there for, whilst hardware still is enabled for the HW video out.
Codec settings would be required in such a case, but those can only be changed from SW mode, or from the codec's own controls.
The KS driver is only needed, if the (PCI-e based) mainboard and VGA card don't allow use of HW video overlay, due to bad PCI latency timing, that can't be tuned.