Page 1 of 1
Can not start device ERROR
Posted: Fri Dec 26, 2008 12:02 pm
by jxid
Hi to all.
I just install ProgDVB 6.02.03 version baut i get the error 'Can not start device'.
I have a PCI Skystar2 card installed with the klatest drivers from Technisat.
Is there anything that i have to do in order to work?
Thanks in advance.
Yannis
[/img]
Posted: Fri Dec 26, 2008 12:26 pm
by Juergen
What kind of driver do you use, normal WDM or BDA?
The SS2 device is for WDM drivers, else start the suitable BDA device.
Posted: Fri Dec 26, 2008 1:57 pm
by jxid
Hi Juergen.
Thanks for the reply.
I am not familiar with Skystar2 so i can't understand what you mean.
I have use the 4.5.0 drivers from Technisat site
http://www.technisat.de/index761b.html? ... 33&pID=174
Also in ProgDVB in device list i have the devices which shown in the image below.
When i try to enable it i get the message:
Posted: Sat Dec 27, 2008 7:57 am
by Juergen
Seems to me, you have a WDM driver, as a BDA device obviously does not exist.
What hardware revision of the SS2 do you have? Perhaps look into Windwos device manager.
Maybe you have to give the Twinhan WDM device a try.
Posted: Sat Dec 27, 2008 8:25 pm
by jxid
I tried the Twinhan WDM but no0 luck!!!
I think that my card is r2.4
[/img]
