DISEQC dosn't work in software mode but is fine in HW mode.

#1
Hi,

my TT card is connected to two LNB's: astra and hotbird using 4/1 diseqc switch. It all works fine when hardware mode is selected but as soon as I switch to software mode it is not possible to switch to hotbird only astra channels work. After switching back to HW mode hotbird channel are working fine again. Is it possible to use DISEQC in software mode and if so how ?
I'm using prog version 4.82.

Regards

#2
Well, this seems to be quite an old bug, meanwhile.

I don't use / test SW mode on my old machine, normally.

But now I did, and DiSEqC did not even work back to 4.7x then.

But does work on 4.62.4, f.e.

All w9x versions here, of course.


BTW, perhaps play with the 'distinguish by' settings.
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>

#3
Thanks a lot! After switching to LNB DISEqC started to work. Normally I wouldn't bother about software mode but I can not get EPG screen in HW mode and in SW mode it works quite nicely (not to mention that OSD in HW is ugly compared to the one in SW mode).