Have the card working now on different ( fta) channels, but on some fta stations still no picture, what i noticed was that a television channel with channel search shows up like a radio channel, and also in the channel properties the pid table give the wrong video pid and pmt value shows wrong ...

Connected tt card directly with video out to video in on television but no picture, only see the epg when switching channel,

after that screen stays black, in hardmode ( in softmode can,t select video out / rgb out )

So this issue don,t have anything to do with the graphic card because i take the ...

Thanks,

Software scale not sucessfull, but this videocard is a much newer then the original setting.

will try with direct video output connected to scart of television, need to make cable first,

This card was always working fine in a pentium 3 350 Mhz!! system with the first! and the later progdvb software.

In hard and soft mode,

This technotrend has a build in mpeg 2 as i can remember, and uses almost zero cpu usage

and now i have tryed with a lot of older prog software and result the ...

Goodevening,


Installed again my /old/technotrend card in a pentium 4 Xp pc, but the screen stays black either in soft or hardmode.

tryed different prog versions but no succes..

Signal and quality seems to be ok..


in options video and audio elecard is chosen, other options did not work aswell ...

Changed processor to 3.4 [ with slight overclock to 3.6 ] which must be enough for this kind of satcard.
technisat / technotrend hd.

When i start up progdvb hd runs fine for about 5 seconds after then cpu runs higher and higher till 100% cpu load and doesn,t come under 100 % anymore.

After restart ...

Ok, thanks for al the help, tryed also with the original [technotrend viewer ] still the same problem.

So i will try other [dual core] instead of pentium 4 3.2 ghz system, think processor power is on the low side.


Will post results here...

Upgraded videocard to 1Gb still the same problem freezes and blocks on hd / sd still ok.

Also tryed other codec pack but no solution aswell, still high 50 - 100 % cpu load on hd +/- 35 % on sd channels.

Also very long [ about 10 - 15 seconds zap time ]


Hereby new log:

Goodafternoon,


I changed to dvxa in ffd show, still freezes and blocks, also did not upgrade my videocard at the moment.

Maybe someone can have a look whats wrong,

Tnx.

Codecs installed, hereby log:

But also upgrade my videocard to 1 Gb,

Tnx.

Thanks for your answer, have installed as described but still some freezes on hd channels,

Think i have to upgrade my videocard as it is under 512 Mb, [ if i have a look for the minimum requirements for Progdvb ]

Will post when i have installed it...

goodevening,

Hereby my log:

Hd freezes Sd channels ok, with Hd high cpu, also tryed other version of Prog,

and stability mode,

Regards

Goodevening,

Installed prog version 6.61.1 pro on my xp pentium 4 system, but on the hd channels i get freezes and black screen, on the sd channels all seems ok.

using ffdshow for codec maybe other is better or fixing this problem.


Maybe someone can help