Freeview - Multiplex 2 Missing

#1
Hello,

I recently started to use ProgDVB and whilst it is an incredibly useful piece of software, in the previous two builds I have yet to scan and find any multiplex 2 channels successfully. I have a Compro VideoMate E700 (which is a BDA device) and when combined with the bundled (limited) software it is able to show all the channels in multiplex 2 without any problems. This leads me to think that ProgDVB is at fault. I have scanned for channels on both the tuners (it is a dual tuner device) and on different freeview transmitters without any luck.

I hope you can help me as this is the only problem I have had with a otherwise excellent piece of software.

Many thanks.

#2
Hello again,

Please ignore my previous message. After playing around with the transponder scan I managed to get all the channels I needed, not entirely sure why it wasn't working in the channel scan but nevermind.

Mods, please close this thread.

Many thanks.

#3
Mods, please close this thread.
Your wish is my command...
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>