I have installed progdvb pro latest version. I had installed TT dirvers version 2.19h (special driver for pcie system form technotrend), when I run in HW mode the image is cutted on the sides, but it is ok when use software mode. The problem disappears with the normal driver 2.19c. How can I use the latest drivers avoiding this problem?
Thanks
#2
2.19c - the good for you.... 2.19h - only have PCIE support... but i dont know what that mean - i have pcie video card and use 2.19c - no problem
(with 2.19h - have same problem as you)
(with 2.19h - have same problem as you)
#3
Where does this happen, on the computer screen or (also) on the hardware video out?
The PCI-e special driver DISABLES hardware mode for the computer screen picture, it FORCES software decoding there for, whilst hardware still is enabled for the HW video out.
Codec settings would be required in such a case, but those can only be changed from SW mode, or from the codec's own controls.
The KS driver is only needed, if the (PCI-e based) mainboard and VGA card don't allow use of HW video overlay, due to bad PCI latency timing, that can't be tuned.
The PCI-e special driver DISABLES hardware mode for the computer screen picture, it FORCES software decoding there for, whilst hardware still is enabled for the HW video out.
Codec settings would be required in such a case, but those can only be changed from SW mode, or from the codec's own controls.
The KS driver is only needed, if the (PCI-e based) mainboard and VGA card don't allow use of HW video overlay, due to bad PCI latency timing, that can't be tuned.
My signature:
Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>
Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>