Display posts from previous
Sort by

ProgDVB lost connection

#1 by Coachi
Hello,
I work with ProgDVB 5.15.6. When I open ProgDVB I can see a picture. After about 10 Minutes my ProgDVB lost the connection and I can`t see a picture. I have tried another version of ProgDVB but it`s already the same error.
Please help me.

mfg

#3 by Coachi
The signal from the antenna is only between 5 and 30%. After I reboot my PC then is the signal good and I can watch TV with ProgDVB. But only about 10 minutes. Then I have the same problem

#5 by Coachi
I don`t think so. The tuner isn`t to hot but to make sure I have maked a cooler into the pc.
After 10 minutes I have the same problem. When I make the tuner in another pc I haven`t the problem.

#6 by Juergen
Coachi wrote:... When I make the tuner in another pc I haven`t the problem.
This means, your problem is indeed supposed to be hardware specific, somehow.
For example, if your tuner is getting to much heat from another PCI card, or it's own heat can't be transported away by the case internal air flow, like caused by drive data cables in the way.
Or perhaps you have a partly bad PCI slot, or power supply, or onboard voltage converters, ...
Even possible, you're having thermal RAM or bus timing trouble. Or some basic settings do differ from the other machine and installation, like timeshift buffer set into RAM, with a to big buffer, related to physical memory size, or some swap file trouble, or energy saving related.
However, this is most likely to be a complex issue, with several components and settings interfering with each other...

Not all computer hardware problems would always cause crashes, they could instead as well let a component and driver fail.
At least, there's a high chance, temperature was involved some way.

No other way to find out, than either watching some system parameters by software, or temporarily change components and slots. Or add an extra case blower, to improve the air flow.
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!


I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!

1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>

#7 by Coachi
Hello,
now I have make the option "only one CPU" and my progdvb doesn`t make an error. I think that`s my solution. Although thanks