I installed ProgDVB in conjunction with a Terratec Cinergy HTC USB XS, DVB-C cable, on WinXP. I setup the the channels manually, the video and audio is ok, but there is something I don't know how to configure, or if there is a limitation that I am not aware of: the channels name. The channels are listed as "TV Service nnn". Is it possible to obtain the name automatically from the stream ?
I can run the same tuner with VLC. While at the very first moment after channel tuning the channels are listed in VLC menu with a similar nnn number as with ProgDVB, after two or three seconds the names changes to the one provided into the stream.
How do I get the same behaviour in ProgDVB ? I know I can rename each channel entry manually, but it's too annoying to consider this a practical solution.
Thank you,
Cristi
#3
I recorded the transport stream, but not with ProgDVB (I don't know how to save all services at once, since the Service menu has only Start recording / Stop recording / Cancel recording positions and the resulted .ts contains only the currently watched program), but with TwinHan BDA TSCapture utility.
The saved sample transport stream file of a single frequency is here. It contains 11 programs, with duration of 42 seconds approx. I limited the file to 199M as per RapidShare requirement. The file is not in a collector account, so it is limited to 10 downloads.
Cristi
The saved sample transport stream file of a single frequency is here. It contains 11 programs, with duration of 42 seconds approx. I limited the file to 199M as per RapidShare requirement. The file is not in a collector account, so it is limited to 10 downloads.
Cristi