Hello,
It is hard to search for topics here so sorry if this is a known problem.
I have a HVR4000 and dieseqc soed not qork with atest version of progdvb. If i switch to Mytheater it works fine.
I saw some timeout values on the diseqc settings, tried it and did not succeed.
It this s known problem?
I used default for almost everything in progdvg and i can scan each of my 4 heads. So diseqc seems to work when scanning but does not when switching channels between SAT.
Ideas appreciated
Thanks for your support!
Best
Dico

Is it work in scan transponder dialog? try add repeats in Settings->Device options

Prog wrote:Is it work in scan transponder dialog? try add repeats in Settings->Device options

disecq is actually working but i have this "level 100 % quality 0" issue...
I see many other forum are mentioning this issue as well.
transponder scan is wokring fine, updating channel is wokring fine. ieven get the channel resolution (720*576 for example).
May be a codec issue but i would have the issue with other software but i do no t.
Just progdvb...
strange
Any other suggestion?

Level and quality readings are NOT a codec issue, but relate with the driver interface, i.e. BDA module and it's options.
Similar to DiSEqC controls, those are manufacturer depending (and sometimes not documented properly for the public).