I have here several adaptors with mulifunction DVB-C AND DVB-T. But when using DVB-C, it is needed to unselect DVB-T adaptor in hardware settings, and vice versa. So when using cable at home (DVB-C) and terrestrial (DVB-C) somewhere else, I always have to select the used adaptor part and deselect the non used. So far so OK.

But EVERY TIME I deselect one of the adaptors I am asked whether to remove all the channels of the removed adaptor and to scan the activated adaptor. But I neither want to remove the channels and nor want to wait until all is scanned again and nothing new found! So where can I stop each time being asked separately?

Please provide a checkbox in the hardware/devices-window that is normally unselected and can be selected in case the channels can be removed.

ProgDVB no have this function... But check "Use only one tuner" in Device options for this this problem.

ps: Channels linked to devices. After you remove device you must remove all channels for this device.