Hi,

I am using ProgDVB software to receive satellite signals. However, I am confused on how to fill in some settings required by this software as shown in the attached. The satellite is Eutelsat 7A and the service provider is OpenSky. Does anybody know how to find out these parameters?

Thanks in advance.

Jane
P.S. I am trying to attach a screen shot for the transponder's list, but I couldn't. A typical line for this transponder's list is: Frequency; Polarization; Symbol Rate; S2; MIS; MOdulation; FEC; Pilot; Roll Off. I was wondering where to get all these choices as well. Thank you.

This is parameters of LNB. Default must be good.