hi every body , I have card sat pinnacle 400i and SG2100 Motor disecq like that
how can i use this motor with progdvb for change satellite ??

What DiSEqC version does that motor need, EXACTLY?
The data sheet / manual should tell you.
Then perhaps look at the 'Modules and plugins' section here.

i think that diseqc 1.2
i heard that my threat can move the dish

I am not have information about diseq function on this card. May be if install twinhan driver...

Start testing with the original application, that came with your card.
If this works well, you are ready to use 3rd party software.
If not, contact the dealer or vendor or manufacturer, please.
Technically, DiSEqC 1.2 should not be a problem for any modern hardware, but also the drivers and it's interfaces have to support it.
Also make sure, not just guess and believe, what DiSEqC method is needed for your motor, exactly. May well be, there's more than one, but even then, this must be specified concretely somewhere in the manual or data sheet for it.

Generally, 3rd party software can't turn a washing machine into a lawn mower, nor could it fix anything broken on hardware, driver or dish setup or wiring...

BTW, one thread on a subject is enough. Second one deleted.

And we are not blind. No need to post in large or huge font size, if that's not important for the message.
If you have reading trouble, either decrease your VGA resolution or adjust your browser settings for aspect, minimum font sizes or similar.
This for I fulfilled my duties as a moderator and edited out some unnecessary tags now