The program crashes after every recording.
The program was started as administrator.
Is there a remedy for this?
Re: Crash after Record
#3Thank you very much for your quick reply.
The output file is created correctly.
The administrator has full rights in the output folder.
Please find attached the log file.
Thank you very much.
- Attachments
-
- ProgLogs.zip
- Hopefully it helps.
- (521.68 KiB) Downloaded 251 times
Re: Crash after Record
#4In logs is normal recording process of....NITRO_5.Oktober.2024.ts
Do you have crash in this time?
Do you have crash in this time?
Re: Crash after Record
#5Sorry, unfortunately no, I must have missed that,
But I have a new .log.
I'll add it again. I had two jobs in there. The last job caused the error again.
But I have a new .log.
I'll add it again. I had two jobs in there. The last job caused the error again.
- Attachments
-
- ProgLogs.zip
- (1.6 MiB) Downloaded 242 times
Re: Crash after Record
#7No, if I have a single recording job per service then I have the same error.
If I have three jobs, then at the end of the third.
If I have three jobs, then at the end of the third.
Re: Crash after Record
#9Yes, I am using the task scheduler.
the program then creates a scheduled task.
This task is stored and started as an administrator.
the program then creates a scheduled task.
This task is stored and started as an administrator.
Re: Crash after Record
#11Try change scheduler mode. Or record path to c:\ProgDVBRecords for example
Re: Crash after Record
#12I tried all that. Unfortunately, it doesn't work either.
I have now installed the old version 7.41.08. With this version it works again, as usual.
I have now installed the old version 7.41.08. With this version it works again, as usual.
Re: Crash after Record
#13And so. Do you use Prog Scheduler? I am not like "Error! Open OpenService FAILED." in logs. Looks like no rights for control of service. try start with Admin rights.