Crash after Record

Harry_41

Crash after Record

#1 by Harry_41

The program crashes after every recording.

The program was started as administrator.

Is there a remedy for this?

Attachments

: ErrorWindow

Re: Crash after Record

#2 by Prog

Check record folder. Please enable logs and send me after next crash.

Harry_41

Re: Crash after Record

#3 by Harry_41

Prog wrote: ↑
Fri Oct 04, 2024 8:37 pm
Check record folder. Please enable logs and send me after next crash.

Thank you very much for your quick reply.
The output file is created correctly.
The administrator has full rights in the output folder.

Please find attached the log file.
Thank you very much.

Attachments

ProgLogs.zip: Hopefully it helps.; (521.68 KiB) Downloaded 218 times

Re: Crash after Record

#4 by Prog

In logs is normal recording process of....NITRO_5.Oktober.2024.ts
Do you have crash in this time?

Harry_41

Re: Crash after Record

#5 by Harry_41

Sorry, unfortunately no, I must have missed that,
But I have a new .log.

I'll add it again. I had two jobs in there. The last job caused the error again.

Attachments

ProgLogs.zip: (1.6 MiB) Downloaded 204 times

Re: Crash after Record

#6 by Prog

Do you have every time crash on second record?

Harry_41

Re: Crash after Record

#7 by Harry_41

No, if I have a single recording job per service then I have the same error.
If I have three jobs, then at the end of the third.

Re: Crash after Record

#8 by Prog

Do you use ProgScheduler?

Harry_41

Re: Crash after Record

#9 by Harry_41

Yes, I am using the task scheduler.
the program then creates a scheduled task.

This task is stored and started as an administrator.

Harry_41

Re: Crash after Record

#10 by Harry_41

Do you have any further helpful ideas?

Re: Crash after Record

#11 by Prog

Try change scheduler mode. Or record path to c:\ProgDVBRecords for example

Harry_41

Re: Crash after Record

#12 by Harry_41

I tried all that. Unfortunately, it doesn't work either.
I have now installed the old version 7.41.08. With this version it works again, as usual.

Re: Crash after Record

#13 by Prog

And so. Do you use Prog Scheduler? I am not like "Error! Open OpenService FAILED." in logs. Looks like no rights for control of service. try start with Admin rights.

Re: Crash after Record

#14 by Prog

Please try ProgScheduler mode in last prerelease of ProgDVB.

Display posts from previous

Sort by