Twinhan DTV Magic BoX Model 7041B

#1
Hello experts,
I have a Twinhan DTV Magic BoX Model 7041B.
It is a DVB-T (terrestrial TV-Receiver).
It works very fine on my computer with the Twinhan original TWINHAN software 2.43 USB-Ter.
Does anybody knows, will it work also with ProgDVB ?
I installed ProgDVB on my computer but it will not work with my Twinhan 7041B.
I allways get a message such as like "no divice connected".
Please give me a note.
Thanks a lot.

( When I connect my DVB-S USB Receiver, it works very fine)

Regards
Harald
Harald Kranold

#2
Look into Windows device manager (Gerätemanager), if this device uses BDA drivers.
If yes, you should be able to find a suitable BDA DVB-T device in ProgDVB's device list as well, which would be the one you have to start.
If not, a specific non-BDA device file would be necessary (if exists), either for it or for a compatible hardware (which I don't know about).
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>