help please!

#1
Hello everybody,

I have a skystar hd3 in my computer and I installed ProgDvb 6.05. And I am trying to configure it. But when I go to settings_device list and I try to activate skystar 2, a red cross over a rectangle appears at the left. {BDA} TechniSat Mantis DVBS BDA Receiver is with a green rectangle. And then when I go to scan transponder the program does not let me to see anything.

Any hel would be appreciated!! thanks in advance

#2
Your device is NOT a SkyStar2. So selecting this is not supposed to work.
Probably you have to select the BDA device and then try out the hardware related settings in device options.
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>