Page 1 of 1
latest progDVB can't find most channels australia
Posted: Sun Jul 19, 2009 6:18 am
by fluffy
hey hey,
i've just updated to the latest progDVB and have chosen the 'Australia - All Channels' as well as done a blind search but can only find 1 channel (Channel9 - both the standard and hi-def versions).
I can't seem to find any other channels!?
I have tried all sorts of different settings but to no avail. The reception is fine, I had no problem with previous versions...
Any help appreciated!!
Posted: Fri Jul 24, 2009 12:30 pm
by StormyKnight
Yep just had the same problem....
However I set my BDA device to advanced in the Device List, this crashed ProgDVB, upon restart I did another scan & all my channels showed up correctly.
Before that I could only get the first transponder in the seach to register channels, oddly when I did a manual scan on a latter transponder, it would come up with the same channels as the first transponder...
I ended up with 30+ channels all from the same transponder.
My issue now is the EPG doesn't seem to work, but it did before the crash !
Cheers
.
Posted: Fri Jul 24, 2009 1:59 pm
by Prog
What DVB device? DVB-T?
Posted: Sat Jul 25, 2009 7:30 am
by StormyKnight
USB 2.0 DVB-T/TV BOX
BTW, I restart the program again & EPG is now working.....
.
Posted: Sat Jul 25, 2009 8:02 am
by Prog
You can try remove epg.dat if problem with EPG.
Do you have any problem with scan transponder dialog?
Posted: Sat Jul 25, 2009 8:51 am
by StormyKnight
No I have what I believe now is full functionality.....
I have disable the advanced BDA since I was getting a message that it was unable to start on each program startup.
I have two other questions though...
1. When I change channels I sometimes get a loud audio spike. It there any muting when a channel is changed?
2. How do I get the onscreen display to come backup other than reselecting that particular channel again?
Cheers