hi, i always used to change channels by pressing number of channel on numpad (I have just 9 active channels, so one number is enough)
but now it stopped working, i dont know what have i done..

in controls it is set ok - i reconfigured it many times over by learn feature (numbers at the end of the list), but the switching just doesnt work. any tips?

What version(s) of ProgDVB, exactly?

What OS?

Does the OSD react in any way, if you enter a num block key?

When does that problem occur, in normal window mode, or maximized, or TV window?

Does the teach in result in num keys being detected / listed?
Avoid doublets.

Details rule...

ok, sorry, but pretty standard config
Win XP SP3, ProgDVB regulary updated, so now 6.22

the thing is, its not even about numpad, but if i set the number keys to any key (i tried the F as seen below), it just doesnt switch the channel after pressing... you can also see that i have only 9 channels, so i used to use numpad 1-9 for direct switching to channel with that number..
it does't respond in any window/mode

learn works fine

no doublets

First check the OSD show time setting. After that has past, a number entry should be executed anyway, normally...
Also try the enter key, to force execute.
And perhaps compare with adequate command line entries.
Prog may possibly need precise reports.

Did not play around with recent 6.x versions yet, no time available ATM.
So these thoughts come from earlier versions.

Sometimes, version updates may cause corruption of a few user settings.
This may in case effect almost any .ini file used.